KimVogels
New Member
Hi,
i have an Xbox 360 original white with a 60gb harddrive.
Now i want to replace the 60gb to a 500gb harddrive (Western Digital WD5000BEVT - 22A0RT0)
I did all the steps from here but when i want to flash the 500gb drive, i get an error "Reading HDD sector 16 failed! DRQ Error: 0x0802"
This is what i did:
Step 1:
The 500gb drive is clean and it has no partition on it.
Step 2:
I downloaded the Bootable USB Drive Creator Tool, HDDHackr 1.40 and the HDDSS500.BIN.
I've made a usb flashdrive bootable and put the HDDHackr and the HDDSS500.bin on it.
Step 3:
The computer booted from the flashdrive and i entered the following commands:
C:\hddhackr and pressed 'enter'
The tool is searching for the 500gb drive and found it.
Step 4:
I selected the harddrive (in my case it was number 7)
Then i get a menu:
What do you want to do?
[D] to dump Sectors 16-22
[C] to create Partition 0/2/3
[F] to flash Firmware
[R] to restore Firmware
i press F to flash the drive
It asks for the HDDSS file so i entered HDDSS500.BIN
then it asks for the UNDO, so i entered UNDO.BIN
Then a get a new screen with the 'Data from selected Hard Drive'
and then, i get the error...
Then i started all over again.
First i created a partition and then i want to flash the drive but im getting the same error.
I tried on different computers, but it wont work.
Who has the solution?
Thanks!
i have an Xbox 360 original white with a 60gb harddrive.
Now i want to replace the 60gb to a 500gb harddrive (Western Digital WD5000BEVT - 22A0RT0)
I did all the steps from here but when i want to flash the 500gb drive, i get an error "Reading HDD sector 16 failed! DRQ Error: 0x0802"
This is what i did:
Step 1:
The 500gb drive is clean and it has no partition on it.
Step 2:
I downloaded the Bootable USB Drive Creator Tool, HDDHackr 1.40 and the HDDSS500.BIN.
I've made a usb flashdrive bootable and put the HDDHackr and the HDDSS500.bin on it.
Step 3:
The computer booted from the flashdrive and i entered the following commands:
C:\hddhackr and pressed 'enter'
The tool is searching for the 500gb drive and found it.
Step 4:
I selected the harddrive (in my case it was number 7)
Then i get a menu:
What do you want to do?
[D] to dump Sectors 16-22
[C] to create Partition 0/2/3
[F] to flash Firmware
[R] to restore Firmware
i press F to flash the drive
It asks for the HDDSS file so i entered HDDSS500.BIN
then it asks for the UNDO, so i entered UNDO.BIN
Then a get a new screen with the 'Data from selected Hard Drive'
and then, i get the error...
Then i started all over again.
First i created a partition and then i want to flash the drive but im getting the same error.
I tried on different computers, but it wont work.
Who has the solution?
Thanks!
It works!